User manual

RSKRX62T 5. User Circuitry
REJ10J2194-0300 Rev.3.00 Page 17 of 40
Nov 08, 2011
5.8 Controller-Area Network (CAN)
A CAN transceiver IC is fitted to the RSK, and is connected to the CAN MCU peripheral. For further details
regarding the CAN protocol and supported modes of operation, please refer to the RX62T hardware manual.
The connections for the CAN microcontroller signals are listed in Table 5-6 below.
CAN Signal Function MCU Connection
CTX-A CAN Data Transmission. PB5, Pin 28
CRX-A CAN Data Reception. PB6, Pin 27
CANEN CAN Transceiver Device Enable Control. P24, Pin 64
CANERRn CAN Error and Power Status. P55, Pin 78
CANSTBn CAN Standby Mode Control. PB0, Pin 35
Table 5-6: CAN Connections
5.9 Local-Interconnect Network (LIN)
A LIN transceiver IC is fitted to the RSK, and connected to the LIN MCU peripheral. For further details regarding
the LIN protocol and supported modes of operation, please refer to the RX62T hardware manual.
The connections for the LIN microcontroller signals are listed in Table 5-7 below.
LIN Signal Function MCU Connection
LTX LIN Data Transmission. P23, Pin 65
LRX LIN Data Reception. P22, Pin 66
LINNSLP LIN Transceiver Device Sleep Control. PA2, Pin 39
Table 5-7: LIN Connections