User manual

RSK+RX62N 5. User Circuitry
REJ10J2198-0201 Rev. 2.01 Page 18 of 54
Nov 30, 2011
5.7 RS232 Serial Port
Serial port SCI2-A is connected to the standard RS232 header fitted to the RSK. Alternatively, serial port SCI1-B or
SCI6-A can be connected to the RS232 transceiver by making changes to the configurations to the jumpers and
option links (refer to §6). Connections between the RS232 header and the microcontroller are listed in the
Table 5-5.
SCI Signal Function MCU Connection RS232 Connection
TxD2-A SCI2-A Transmit Signal. P13, Pin P5 Pin 2
RxD2-A SCI2-A Receive Signal. P12, Pin R3 Pin 3
TxD1-B SCI1-B Transmit Signal. PF0, Pin K3 Pin 8*
RxD1-B SCI1-B Receive Signal. PF2, Pin L1 Pin 7*
TxD6-A SCI6-A Transmit Signal. P00, Pin C1 Pin 2*
RxD6-A SCI6-A Receive Signal. P01, Pin D2 Pin 3*
Table 5-5: Serial Port Connections
* This connection is a not available in the default RSK+ configuration - refer to §6 for the required modifications.
5.8 Controller-Area Network (CAN)
A CAN transceiver IC is fitted to the RSK+, and is connected to the CAN MCU peripheral. For further details
regarding the CAN protocol and supported modes of operation, please refer to the RX62N hardware manual.
The connections for the CAN microcontroller signals are listed in Table 5-7 below.
CAN Signal Function MCU Connection
CTX0 CAN Data Transmission. P32, Pin J2
CRX0 CAN Data Reception. P33, Pin K1
CANEN CAN Transceiver Device Enable Control. P42, Pin A3
CANERRn CAN Error and Power Status. P43, Pin D5
CANSTBn CAN Standby Mode Control. P41, Pin D4
Table 5-6: CAN Connections