Technical information

Section 3 Software Specifications when Using the SH7080 Series/SH7146 Series/SH/Tiny Series
Rev. 5.00 Aug. 18, 2009 Page 36 of 78
REJ10J1237-0500
Sequential Setting: Using the [Combination action (Sequential or PtoP)] dialog box specifies the
sequential condition and the start or end of performance measurement.
Table 3.8 Conditions to Be Set
Classification Item Description
[Ch1, 2, 3] list box Sets the sequential condition and the start or end of performance
measurement using Event Conditions 1 to 3.
Don’t care Sets no sequential condition or the start or end of
performance measurement.
Break: Ch3-2-1 Breaks when a condition is satisfied in the order of
Event Condition 3, 2, 1.
Break: Ch2-1 Breaks when a condition is satisfied in the order of
Event Condition 2, 1.
I-Trace stop: Ch3-2-1 Halts acquisition of an internal trace when a
condition is satisfied in the order of Event Condition
3, 2, 1.
I-Trace stop: Ch2-1 Halts acquisition of an internal trace when a
condition is satisfied in the order of Event Condition
2, 1.
Ch2 to Ch1 PA Sets the performance measurement period during
the time from the satisfaction of the condition set in
Event Condition 2 (start condition) to the
satisfaction of the condition set in Event Condition
1 (end condition).
Ch1 to Ch2 PA Sets the performance measurement period during
the time from the satisfaction of the condition set in
Event Condition 1 (start condition) to the
satisfaction of the condition set in Event Condition
2 (end condition).
[Ch4, 5] list box Sets the point-to-point of the internal trace (the start or end condition of
trace acquisition) using Event Conditions 4 and 5.
Don’t care Sets no start or end condition of trace acquisition.
I-Trace: Ch5 to Ch4
PtoP
Sets the acquisition period during the time from the
satisfaction of the condition set in Event Condition
5 (start condition) to the satisfaction of the
condition set in Event Condition 4 (end condition).