Technical information

Section 1 System Configuration
Rev. 5.00 Aug. 18, 2009 Page 10 of 78
REJ10J1237-0500
3. The user system interface board is only used when the emulator is connected to the
user system; it is not required when the emulator system operates alone.
(2) System Configuration of the SH/Tiny Series and SH7146
Table 1.4 shows the system configuration supported by the SH/Tiny series (R5F71250/
R5F71251/R5F71252/R5F71253/R5F71240/R5F71241/R5F71242/R5F71243) and SH7146.
Table 1.4 System Configuration Supported by the SH/Tiny Series and SH7146 E200F
E200F Emulator
R0E0200F1EMU00
EV-chip Unit
R0E570800VKK00
External Bus
Trace Unit
R0E0200F1ETU00
Emulation
Memory Unit
R0E0200F1MSR00
R0E0200F1MSR01
Expansion
Profiling Unit
R0E0200F0EPU00
Trace Cable
R0E0200F0ACC00
User
System
Interface
Board
System
configuration
1
*1
Supported Not supported Not supported Not supported Not supported Not supported Not
supported
System
configuration
2
Supported Supported Not supported Not supported Not supported Supported Supported
*2
System
configuration
3
Supported Supported Not supported Not supported Supported Supported Supported
*2
Notes: 1. When system configuration 1 is used, the H-UDI port connector must be installed on the
user system. When designing the user system, refer to section 2.3, Connecting the
Emulator to the User System by Using the H-UDI Port Connector. For system
configuration 1, note that the H-UDI pin of the MCU is occupied by the emulator.
2. The user system interface board is only used when the emulator is connected to the
user system; it is not required when the emulator system operates alone.