Technical information

Section 1 System Configuration
Rev. 5.00 Aug. 18, 2009 Page 9 of 78
REJ10J1237-0500
Table 1.3 System Configuration Supported by the SH7080 Series and SH7149 E200F
E200F Emulator
R0E0200F1EMU00
EV-chip Unit
R0E570800VKK00
External Bus
Trace Unit
R0E0200F1ETU00
Emulation
Memory Unit
R0E0200F1MSR00
R0E0200F1MSR01
Expansion
Profiling Unit
R0E0200F0EPU00
Trace Cable
R0E0200F0ACC00
User
System
Interface
Board
System
configuration
1
*1, *2
Supported Not supported Not supported Not supported Not supported Not supported Not
supported
System
configuration
2
Supported Supported Not supported Not supported Not supported Supported Supported
*3
System
configuration
3
Supported Supported Supported Not supported Not supported Supported Supported
*3
System
configuration
4
Supported Supported Not supported Supported Not supported Supported Supported
*3
System
configuration
5
Supported Supported Supported Supported Not supported Supported Supported
*3
System
configuration
6
*1, *2
Supported Not supported Not supported Not supported Supported Not supported Not
supported
System
configuration
7
Supported Supported Not supported Not supported Supported Supported Supported
*3
System
configuration
8
Supported Supported Supported Not supported Supported Supported Supported
*3
System
configuration
9
Supported Supported Not supported Supported Supported Supported Supported
*3
System
configuration
10
Supported Supported Supported Supported Supported Supported Supported
*3
Notes: 1. When system configuration 1 or 6 is used, the H-UDI port connector must be installed
on the user system. When designing the user system, refer to section 2.3, Connecting
the Emulator to the User System by Using the H-UDI Port Connector. For system
configuration 1 or 6, note that the H-UDI pin of the MCU is occupied by the emulator.
2. When system configuration 1 or 6 is used, note that the AUD pin of the MCU is
occupied by the emulator.