User`s manual

7Windows/Dialogs

7.1.2 Setting the RAM monitor area

Choose the popup menu [RAM Monitor Area...] in the RAM monitor window.

The RAM monitor area setup window shown below will appear. The currently set RAM monitor areas

are listed in this window.

Use this window to add, delete or change RAM monitor areas.

• Specify a RAM monitor area by its start address and size (the latter by a number of blocks.)

• The start address can be specified in 0x100 byte units.

If you specify a non-aligned address value, it is rounded off to the nearest address value in 0x100

byte units before being set.

• Specify the size of the RAM monitor area by a number of blocks.

For the PC7501, one block is 256 bytes in size. Up to 16 blocks can be specified.

• RAM monitor areas can be added until the total number of blocks used reaches 16.

(The number of blocks (and the size) that are currently available to use are displayed below the

list.)