User`s manual

5 Setup the Debugger

5.4 Setup the Debugger for M16C/R8C

5.4.1 MCU Setting Dialog

In the MCU Setting dialog box, setting information on the user target. The MCU Setting dialog box

opens after closing the Init dialog box.

The tabs available on this dialog box vary with each product used. For details, click the desired tab

name shown in the table below.

Tab Name

Contents

MCU Specify the MCU's processor mode, debug options, etc.

MAP Set memory areas into which emulation memory is mapped.

Flash Clear Specify whether to clear the contents of the MCU's internal flash ROM.

To keep the MCU Setting dialog box closed next time the debugger is started, check "Next Hide" at

the bottom of the MCU Setting dialog box. You can open the MCU Setting dialog using either one of

the following methods:

After the debugger gets started, select Menu - [Setup] -> [Emulator] -> [Target...].