User`s manual

5 Setup the Debugger

5.3.1.1 Status Tab

The specified content becomes effective when the next being start.

5.3.1.1.1. Select the Processor Mode

Specify the processor mode for the target system.

Either the following can be specified.

• Single-chip Mode

Single-chip Mode

• Memory Expansion 8 Bit

Memory Expansion Mode (8 bits bus width)

• Memory Expansion 16 Bit

Memory Expansion Mode (16 bits bus width)

• Microprocessor 8 Bit

Microprocessor Mode (8 bits bus width)

• Microprocessor 16 Bit

Microprocessor Mode (16 bits bus width)

5.3.1.1.2. Inspecting the MCU status

Clicking this tab displays the status of each MCU pin. It allows to check whether the MCU pin status

matches the processor mode to be set.

If the slider is at the middle position, it means that the value is indeterminate.