User`s manual

12 Attention
12.2.7 MR STK script command
• The MR STK BASE command automatically sets the area where the stack consumption can be
measured. The area set by this command is range of 256KB including the start address of the
system stack. If you want to set other area, please use not the MR STK BASE script command
but the CoVerage BASE script command.
• In the MR STK SYS and MR STK TSK script command, if the address range of a stack area is
across the boundary of the coverage measurements area, the coverage measurement result of the
stack area is not displayed correctly (always displayed as "*****").
265