User`s manual

12.1.10 Notes for coverage function
Coverage Measurement is a function to record the addresses accessed by the target program.
These accessed addresses will flow to the microcomputer address bus.
This may cause unexecuted addresses to be treated as executed addresses when calculating coverage.
12.1.11 Emulator reset switch
If system reset of the emulator does not function normally, terminate the debugger, turn ON the
emulator again, and restart the debugger.
Then re-download the program.
12.1.12 Debugging Resource on Emulator
The debugging resource on the emulator is shared the window/between the dialogs plurals.
Therefore, either of the window/the dialog which can be used at the same time is only one.
Trace Event
Trace Point Setting Window(TracePoint Command)
MR Trace Window/MR Analyze Window
Task Trace Window/Task Analyze Window
Time Measurement Window
12.1.13 The start of the emulator and the debugger
Please start your debugger after the target status LED (ERROR) of the PC7501 goes out, because
PC7501 will not communicate with debugger while the PC7501 is beginning to run just after being
powered on.
12.1.14 The task pause function in using the address match interrupt break
function
The task pause function uses the address match interrupt function. So when the target program uses
the address match interrupt, you can not use the task pause function.
When you use the address match interrupt break function, you can not use the task pause fuction,
too.
12.1.15 The result of Coverage measurements
In the Coverage window and CoVerage FUNC script command, if the address range of a function is
across the boundary of the coverage measurements area, the coverage measurement result of the
function is not displayed correctly (always shown as "*****").
In addition, the CoVerage TOTAL command displays a coverage result for each block, when the
address range specified by this command corresponds to the above-mentioned conditions.
262