User`s manual

7.10.5 Specify the Trace Write Condition
Conditions for cycles to be written to trace memory can be specified.
Total
Writes all cycles.
Pick up Writes only the cycles where specified condition holds true.
Exclude Writes only the cycles where specified condition does not hold true.
Also, following three write modes are supported.
Only cycles where specified event is established
Cycles from where specified event is established to where
specified event is not established
Cycles from where start event is established to where end
event is established
7.10.6 Command Button
The buttons on this window has the following meanings.
Butto n Function
Reset Discards the contents being displayed in the window and loads contents from the
emulator in which they were set.
Save... Saves the contents set in the window to a file.
Load... Loads event information from a file in which it was saved.
Set Sends the contents set in the window to the emulator.
Close Closes the window.
150