User`s manual

7Windows/Dialogs
• When State Transition is selected
Click the Details... button, and the dialog box shown below appears. Specification by a state
transition diagram or Sequential specification can be used. If the content of any event is altered,
it is marked with an asterisk (*) on the title bar. Once conditions are set in the emulator,
asterisks are not displayed. A time-out time in each state can also be specified.
7.10.3 Specify the Process ID
By specifying a process ID, it is possible to detect only event establishment under specific conditions.
Example: Enable only the event that occurs in a specific task when using the realtime OS.
7.10.4 Specify the Trace Range
For the PC7501 emulator debugger, 256K cycles equivalent of data can be recorded.
Break
Stores the 256K cycles (-256K to 0 cycles) to the point at which the target program
stops.
Before Stores the 256K cycles (-256K to 1 cycles) to the point at which the trace point is
passed.
About Stores the 256K cycles (-128K to 128K cycles) either side of the trace point.
After Stores the 256K cycles (0 to 256K cycles) of trace data after the trace point.
Full Stores the 256K cycles (-256K to 0 cycles) of trace data after the trace starts.
149