User guide

CSPC7501R-2:1
Using the emulator
15
EDIT MEMORY MAP DIALOG BOX
In the Edit Memory Map dialog box—available from the Hardware Setup dialog
box—you can specify emulation memory areas.
Figure 10: Edit Memory Map dialog box
Memory range
Use these settings to define the emulation memory areas:
The following memory types are available:
Unallocated memory areas, except the SFR area, are always set as guarded, which
means that they are read- and write-protected. If an application reads or writes in
guarded memory or writes in ROM, the execution is stopped.
Type The memory type; see Table 4, Available memory types in the emulator.
Start address The start address for the memory area, in hexadecimal notation.
End address The end address for the memory area, in hexadecimal notation.
Type Description
SFR Area The size of the SFR area is defined by the device description file.
Internal RAM The size of the Internal RAM area is defined by the device description
file.
Emulation RAM The emulator alternate RAM area, which can be selected in steps of 4
Kbytes. Up to four emulation RAM areas can be defined. This is the
only memory area whose size can defined in this dialog box.
Internal DATA/FLASH The size of the Internal DATA/FLASH area is defined by the device
description file.
Internal FLASH/ROM The size of the Internal FLASH/ROM area is defined by the device
description file.
Table 4: Available memory types in the emulator