User`s manual

27 / 46
4.2.2 Connecting by USB Interface
IMPORTANT
We do not ensure the operation in every combination with host machine, USB device, and USB
hub.
The procedure to set up your system using the USB interface is shown below.
Turn OFF the power to the emulator PC7501.
Set the interface selection switch on the rear panel to "USB".
3.2.1 Interface Selection Switch (P.20)
Connect the USB interface cable to the USB port of the host machine.
Figure 4.4 Connecting the USB interface cable (host machine side) (P.28)
Connect the cable to the USB interface connector on the emulator PC7501.
Figure 4.5 Connecting the USB interface cable (emulator PC7501 side) (P.28)
Connect the emulation probe to the connector on the emulator PC7501.
4.3 Connecting Emulation Probe M3xxxxTx-EPB (P.33)
Connect the emulation probe and the target system.
See the user's manual of the emulation probe
Turn ON the power to the host machine and then turn ON the power of the PC7501 and the target
system as simultaneously as possible.