User`s manual

15 / 46
2.4 Specifications
Table 2.1 lists the specifications of the emulator PC7501.
Table 2.1 Specifications
Supported MCUs M16C Family (32/16-bit, 16-bit)
Max. operating clock frequency 66.7 MHz *
1
Emulation memory The default is 4 MB *
2
Software break 64 points
Hardware break 16 points *
3
(Execution address/Bus detection/Interrupt/External trigger
signal)
Hardware break condition - AND/OR/AND (same time)/State transition
- Pass count: 255 times
Exception event detection Access protect
Real-time trace - 256K cycles
- Trace data: Bus, external trigger, and time stamp
- Five trace modes: Break/Before/About/After/Full
- Can be recorded ON/OFF by events
Real-time RAM monitor - 4,096 bytes (256 bytes x 16 blocks)
- Data/Last access result
Execution time measurement - Execution time between program start to stop.
- Maximum/minimum/average execution time and pass count of
specified four zones.
- Count clock: Equal to MCU Clock or 16 MHz
C0 coverage 8,192 KB (256 KB x 32 blocks)
External trigger input/event
output
External trigger input (MCU-dependent-voltage CMOS level x8)
or event output (break x1, event x7)
Host machine interface - LPT parallel (ECP, EPP, Byte/compatibility and
Nibble/compatibility modes)
- USB (USB 1.1, full-speed)
- LAN (10BASE-T)
Connection to the target system By way of an emulation probe (optional)
(For details, see emulation probe data sheets.)
AC supply voltage for emulator
unit
Supplied from an included AC adapter (100 - 240 V, 50/60 Hz)
Power consumption 48 W maximum
External dimensions *
4
Width: 433 mm, Depth: 140 mm, Height: 58 mm
Weight 740 g
Operating environmental
conditions
- Temperature: 5° to 35°C
- Humidity: 20% to 80% (non-condensing)
- Dust and dirt: General office environment
Storage environmental
conditions
- Temperature: -10° to 60°C
- Humidity: 0% to 90% (non-condensing)
- Dust and dirt: General office environment
Overseas standards - US EMI Standards: FCC part 15 Class A
- CE marking: EN55022 Class A, EN55024
*1 Target-MCU-dependent. (For details, see an emulation probe user's manual.)
*2 Available memory and the required wait states depend on the target MCU. (For details, see an
emulation probe user's manual.)
*3 The number of user-settable hardware break points depends on the specifications of the
emulator debugger M3T-PDxxF.
*4 For details of the external dimensions, refer to "7.1 External Dimensions of the Emulator
PC7501" (P.43).