User`s manual

3.Installing Software

3.2. Recognizing FoUSB and installing USB driver

Recognize the FoUSB and install the USB driver by connecting the FoUSB to the host

computer.

1)Copy the USB Drivers folder in \ENGLISH\KD38 on the CD-ROM to the hard disc in

the host computer. This manual describes the situation when the USB Drivers folder

on the C drive is copied.

2)Remove the FoUSB cover and ensure the FoUSB is set as follows before connecting

the FoUSB. When the FoUSB is not set as follows, modify the setting. Place the

cover of the FoUSB after verifying the setting.

Power supply switch (S1: Power Mode): USB

MCU mode pin (JP1: MCU Mode): Open

3)Connect the FoUSB to the host computer. Since Windows detects new hardware,

recognizing the FoUSB and installing the USB driver start.

JP1: Open

S1:USB side

Host Computer

USB Cable

FoUSB