User`s manual

M3T-PD32R V.5.01 Release 00 Release Notes
Rev.1.00 10.01.2006 page 10 of 34
REJ10J1495-0100
5.3. Zone time measurement event
Setup of zone time measurement events has the following restrictions:
" When the same event is set for the start and end events, 1/2 of the event occurrence count will
be a measurement result.
" Set the start event and end event at interval of more than 200 ns in-between.
5.4. Event setup
When setting an event in the state transition chart in the H/W Break Point Setting Window or Trace
Point Setting Window, observe the following restriction:
" If you specify a chip event and another event under other condition within the event assignment
button, the relation of occurrence time may be inverted, which will cause the system to fail to
correctly recognize the event to be specified in the state transition chart. To mix designation of
these events, occurrence of each event requires interval longer than the time measurement error
given in "
5.2 Zone time measurement error".