Datasheet

Page 22
19fo6002,13.naJ14.1.veR
1410-3100B30JER
)T38/C23M,38/C23M(puorG38/C23M
Address Register Symbol Value after RESET
000016
000116
000216
000316
1000 0000 2 (CNVss pin ="L")
000416 Processor Mode Register 0
(1)
PM0
0000 0011 2 (CNVss pin ="H")
000516 Processor Mode Register 1 PM1 0X00 00002
000616 System Clock Control Register 0 CM0 0000 X0002
000716 System Clock Control Register 1 CM1 0010 00002
000816 Wait Control Register
(2)
WCR 1111 11112
000916 Address Match Interrupt Enable Register AIER XXXX 00002
000A16 Protect Register PRCR XXXX 00002
XXXX 1000 2 (BYTE pin ="L")
000B16 External Data Bus Width Control Register
(2)
DS
XXXX 0000 2 (BYTE pin ="H")
000C16 Main Clock Division Register MCD XXX0 10002
000D16 Oscillation Stop Detection Register CM2 0016
000E16 Watchdog Timer Start Register WDTS XX16
000F16 Watchdog Timer Control Register WDC 000X XXXX2
001016
001116 Address Match Interrupt Register 0 RMAD0 00 00 0016
001216
001316
001416
001516 Address Match Interrupt Register 1 RMAD1 00 00 0016
001616
001716 VDC Control Register for PLL PLV XXXX XX012
001816
001916 Address Match Interrupt Register 2 RMAD2 00 00 0016
001A16
001B16 VDC Control Register 0 VDC0 0016
001C16
001D16 Address Match Interrupt Register 3 RMAD3 00 00 0016
001E16
001F16
002016
002116
002216
002316
002416
002516
002616
002716
002816
002916
002A16
002B16
002C16
002D16
002E16
002F16
X: Indeterminate
Blank spaces are reserved. No access is allowed.
NOTES:
1. The PM00 and PM01 bits in the PM1 register maintain values set before reset even if software reset or watchdog timer reset is performed.
2. These registers in M32C/83T cannot be used.
4. Special Function Registers (SFR)