Datasheet

M16C/62P Group (M16C/62P, M16C/62PT) 5. Electrical Characteristics
Rev.2.41 Jan 10, 2006 Page 49 of 96
REJ03B0001-0241
NOTES:
1. Referenced to V
CC1=VCC2=4.2 to 5.5V, VSS = 0V at Topr = −20 to 85°C / −40 to 85°C, f(BCLK)=24MHz unless otherwise
specified.
2. With one timer operated using fC32.
3. This indicates the memory in which the program to be executed exists.
4. I
det is dissipation current when the following bit is set to “1” (detection circuit enabled).
I
det4: VC27 bit in the VCR2 register
I
det3: VC26 bit in the VCR2 register
Table 5.12 Electrical Characteristics (2)
(1)
Symbol Parameter Measuring Condition
Standard
Unit
Min. Typ. Max.
I
CC Power Supply Current
(V
CC1=VCC2=4.0V to 5.5V)
In single-chip
mode, the output
pins are open and
other pins are V
SS
Mask ROM
f(BCLK)=24MHz
No division, PLL operation
14 20 mA
No division,
On-chip oscillation
1mA
Flash
Memory
f(BCLK)=24MHz,
No division, PLL operation
18 27 mA
No division,
On-chip oscillation
1.8 mA
Flash Memory
Program
f(BCLK)=10MHz,
VCC1=5.0V
15 mA
Flash Memory
Erase
f(BCLK)=10MHz,
VCC1=5.0V
25 mA
Mask ROM
f(XCIN)=32kHz
Low power dissipation
mode, ROM
(3)
25 µA
Flash Memory
f(BCLK)=32kHz
Low power dissipation
mode, RAM
(3)
25 µA
f(BCLK)=32kHz
Low power dissipation
mode, Flash Memory
(3)
420 µA
On-chip oscillation,
Wait mode
50 µA
Mask ROM
Flash Memory
f(BCLK)=32kHz
Wait mode
(2)
,
Oscillation capability High
7.5 µA
f(BCLK)=32kHz
Wait mode
(2)
,
Oscillation capability Low
2.0 µA
Stop mode
Topr =25°C
0.8 3.0 µA
I
det4 Low Voltage Detection Dissipation Current
(4)
0.7 4 µA
I
det3 Reset Area Detection Dissipation Current
(4)
1.2 8 µA