Datasheet

M16C
Target Setup for the FoUSB Programme
r
REU05B0059-0101Z March 2004
Page 7 of 7
Note: If you cannot find your M16C Flash MCU in the examples shown, please contact Renesas representative for
assistance.
4.0 Conclusion
The ICD is an easy-to-use interface for setting up an M16C MCU development environment to support in-system
programming. It does not require a lot of resources from the target board. Correct hardware connectivity will
guarantee proper operation.
5.0 Reference
Renesas Technology Corporation Semiconductor Home Page
http://www.renesas.com
E-mail Support
[e-mail]
User’s Manual
•
RTA-FoUSB-MON User’s Manual
•
Target Setup for In-Circuit Debugger App Note
•
Firmware Requirements for In-Circuit Debugger Support App Note
!RESET
BUSY
Vcc
CLK
RxD
CE
GND
CNVss
TxD
EPM
1
2
3
4
5
6
7
8
9
10
Vcc
P6_4/RTS1 (Busy)
P6_5/CLK1 (SCLK)
P6_6/RxD1 (RxD)
P5_0/WRL (CE)
Vss
!RESET
CNVss
P6_7/TxD1 (TxD)
10-Pin
Header
Vcc
47K
(nominal)
P5_5/HOLD (EPM)
M16C/62P, M16C/6N,
M32C/83
in Single Chip Mode
User UART/
SIO Circuit
Risolation
1K (nominal)
When only used in programming (i.e. no debug operation) and user
uses boot UART, CE, and EPM pins, connect 1K (nominal) isolation
resistors between user UART, CE, & EPM circuit and M16C MCU - 10-
pin header connection.
User GPIO/
Hold Ckt
Risolation
1K (nominal)