Datasheet

M16C
Target Setup for the FoUSB Programme
r
REU05B0059-0101Z March 2004
Page 2 of 7
PC with Windows™ 98,
2000, Me, or XP and
available USB port
Figure 1 ICD System Connectivity
A picture of the ICD with key components indicated is shown below.
Mini-USB
Connector
2
Target or (USB) Bus
Powered Switch
1
LED’s:
Red – Target Stopped
Green – Target Running
Yellow – USB-Monitor Status
Red – Power
10-pin Polarized
Connector to M16C
Tar
g
et Board
2
Figure 2 ICD (or USB-Monitor)
Note:
1. The USB Bus Power Mode was designed to supply power to Renesas SKP boards.
If non-Renesas SKP boards (i.e. customer developed M16C board) are used as target boards, use the ICD in Target
Power mode. Contact your Renesas representative if you plan to use the ICD in Bus Power mode to supply power to
your non-SKP target board.
2. The ICD ships with a 6’ mini USB cable to connect to your PC and a 6” 10-pin flat ribbon target cable to connect to
the M16C target board.