Datasheet

M16C/2
6
Programming Flash Memory via Flash-Over-USB™
REU05B0042-0100Z June 2003
Page 5 of 8
4.2 Selecting Target MCU
To select the firefly as target MCU, perform the following steps.
1. Click on Select MCU on the FoUSB main GUI. A Chip Selection GUI appears as shown in Figure 7.
2. Click on
M16C/26
from the Select MCU Family option. M30262F8_DBC appears as a part number in the
Select MCU Part Number option.
3. Click on M30262F8_DBC under Select MCU Part Number to highlight it. Then press OK. This selects the
target firefly MCU chip and the Chip Selection GUI disappears. The selected MCU (M30262F8_DBC)
appears on the start-up GUI besides Select MCU as shown in Figure 6.
Figure 7 Chip Selection GUI
4.3 Selecting Target Program
To select a target program, perform following steps:
1. Click on OPEN on FoUSB main GUI. Windows file selection menu appears as shown in Figure 8.
2. Find the target file (e.g., xxxx.mot) for loading into MCU flash, highlight the file, and then click on Open of
Windows file selection menu. The target file is thereby selected and the file selection menu disappears. The
selected target file appears on FoUSB main GUI beside FILE as shown in figure 9.