Hardware manual

5 / 5
2.3 Usage with Other Products
To install the SuperH™ RISC engine C/C++ compiler package or H8S, H8/300 series C/C++ compiler
package after installing the E6000H emulator software for HEW, select [High-performance Embedded
Workshop] as the component to be installed in [Select Components] during installation of the compiler
package.
3 Connecting the User System Interface Board
Before connecting the evaluation chip board and the user system interface board, check that pin 1 of each of
the connectors is correctly aligned.
4 Reducing EMI Noise
To prevent EMI noise, enclose the evaluation chip board in a case at usage, as shown in the figure below.
The recommended material of the case is iron plated with nickel. For EMI compliance, we have used a case
made of iron plated with nickel during testing.
The case must be large enough to include the evaluation chip board and the user system.
The opening in the case (on the top) should be large enough to let the emulator trace cable go through.
Note: EMI stands for Electrical Magnetic Interference.
E6000H station
User system
E6000H
RENESAS