Technical information

26
3.8 Reading the FLASH ROM Data
1. Display the ‘Upload Image’ dialog box from [Device->Upload Image].
2. Enter the start and end addresses.
3. Click the ‘Upload’ button to start reading.
4. When ‘Successfully read xxx bytes from device’ is displayed in the message window, reading is complete.
If the user specifies an Absolute image, the uploaded data will be placed in an image the size of the FLASH
memory at the same address it was uploaded from. Use an Absolute Image if the uploaded data needs to be
added to the project. It is not possible to upload a region outside of the FLASH into an Absolute Image.
Note When FDT is started in boot mode, the flash memory data has already been erased.
Figure 3-17 Upload Image Dialog