User`s manual

49
The following messages are displayed during the test. There are 13 steps in this test.
Message Description
E6000H H8SX/1650 Emulator Tests V*.* Test program start
Copyright (c) 2003 Renesas Technology Corp. message. x.x shows
the version number.
Loading driver .........................OK (Use PCI) Shows that the PC
interface board is
correctly installed in
the host computer.
Initializing driver ....................OK
Searching for interface card ...........OK
Checking emulator is connected .........OK Shows that the E6000H
emulator is correctly
connected to the host
computer.
Emulator board information:
Main board ID: H'* Emulation board ID: H'*** Shows the ID number of
the E6000H emulator.
Normal started at WWW MMM DD hh:mm:ss YYYY Shows the time when the
diagnostic program was
started up.
******* NORMAL TEST - Press 'Q' to stop ******* (COUNT=0001)
1. Main Board Access
01) Registers Initial Value Check ..........................OK
02) Registers Write/Verify .................................OK
03) DPRAM Address Decode Test ..............................SKIP
04) DPRAM Marching Test ....................................SKIP
05) Trace Memory Address Decode Test .......................OK
06) Trace Memory Marching Test .............................OK
07) G/A Registers Initial Value Check ......................OK
08) G/A Registers Write/Verify .............................OK
2. Emulation Board Access
01) Registers Initial Value Check ..........................OK
02) Registers Write/Verify .................................OK
03) RESERVED
04) RESERVED
05) RESERVED
06) RESERVED
07) RESERVED
08) Firmware RAM Address Decode Test .......................SKIP
09) Firmware RAM Marching Test .............................SKIP
10) MAP Control RAM Address Decode Test ....................OK
11) MAP Control RAM Marching ...............................OK
3. Evaluation Board Access
01) Registers Initial Value Check ..........................OK
02) Registers Write/Verify .................................OK
03) H-UDI IDCODE Check .....................................OK
04) Firmware BOOT ..........................................OK
05) Configuration Set ......................................OK
4. Basic Function
01) GO to BREAK ............................................OK
02) RESET GO ...............................................OK
03) STEP ...................................................OK
04) KEYBREAK ...............................................OK
05) BRKCONT ................................................OK
06) Internal ROM Address Decode Test .......................OK
07) Internal ROM Marching Test .............................OK
08) Internal RAM Address Decode Test .......................OK
09) Internal RAM Marching Test .............................OK
10) Emulation RAM Address Decode Test ......................OK
11) Emulation RAM Marching Test ............................OK
12) MAP Break ..............................................OK
5. GO to BREAK Time Measurement
01) Counter Test Mode (EMU 12MHz MPU 12MHz Sampling 20ns) ..OK