User`s manual

11
2.2.3 Connection by the User System Interface Connectors
WARNING
Always switch OFF the emulator and user system before
connecting or disconnecting any CABLES. Failure to do so will result
in a FIRE HAZARD, and will damage the user system or emulator or
result in PERSONAL INJURY. Also, the USER PROGRAM will be LOST.
For correct connection, check the location of pin 1.
Connect pin 1 on the user system connector to the connector installed at the bottom of the E6000H user system
interface board. When connecting the connector, prevent the upper or lower side of the board from lifting off the
connector. Alternately tighten the screws on both sides of the board.
Note: This evaluation chip board can only be used in combination with the specified dedicated connectors
(WD-200P-VF85-N).
Install the connectors (WD-200P-VF85-N manufactured by Japan Aviation Electronics Industry, Ltd.) on the
user system to connect the emulator. Figures 2.2 to 2.4 show connection using the dedicated connector, size
restrictions for the installed components, and the location for mounting the connector in the user system,
respectively.