User`s manual

84
3.12.4 Performance Measurement (Conditions for Measurement)
The following conditions are included among those selectable under the [Measurement Method] option for
measurement of execution.
Setting the [Measurement Method] option:
[Performance Analysis Properties] page: Sets a condition for measurement.
[TASK ID]: Allows specification of the values set for [TASK Selection 1]
to [TASK Selection 3] in the [RTOS Support Function
Configuration Properties] dialog box as conditions. To set
values other than those specified in [RTOS Support Function
Configuration Properties] as a condition, select [OTHER] here.
3.12.5 Event Point (On-Emulator Breakpoint)
When selecting [TASK Selection], the condition is changed as follows.
[Address] page in the [On Emulator Break Channel n] dialog box:
[Address]: Sets the address bus condition.
[Outside Range]: [Outside Range] is disabled.
[TASK ID]: [TASK ID] is added to the [Address] page. The [TASK
Selection 1] to [TASK Selection 3] settings in the [RTOS
Support Function Configuration Properties] dialog box are
selectable as conditions. To set values other than those
specified in [RTOS Support Function Configuration Properties]
as a condition, select [OTHER] here.
Note: For values set for the RTOS extension function, refer to section 5.11, RTOS Extension Function.