User`s manual

[RTOS Support Function]: Sets up the RTOS extension function.

[Don’t Care]: Disables the RTOS extension function.

[TASK ID writing area]: Specifies the address where the task ID is written to in the

RTOS.

[TASK ID writing area] input edit box: Specifies the address where the task IDs are written.

Set an address within the on-chip I/O area that does not

contain I/O registers.

[Setting...]: When using the kernel library for E6000H RTOS-

debugging support on the Renesas’ HI1000/4, searches

for the address to which the area for E6000H debugging

has been allocated.

[TASK Selection]: Selects task IDs for use in setting conditions for the on-

emulator break, tracing, performance analysis, and the display

of trace information.

[Don’t Care]: Disables [TASK Selection].

[TASK Selection N] (N = 1 to 3): Enables the TASK Selection N condition for use as an

on-emulator breakpoint. Setting a TASK Selection N

condition as an on-emulator breakpoint, etc. specifies

the task ID or OS, as specified in [TASK Selection N],

as a condition.

Drop-down list for selecting a task ID or OS: Select the task ID or OS. A task ID of 0 selects

the OS.

Edit box for entering a task ID: Set a task ID within the range from D’1 to D’255.

[TASK STEP]: Specifies step operation in task units.

[Enable]: Selection enables step operation in task units.

3.12.2 Task Step Functions

When [Enable] under [TASK STEP] in the [RTOS Support Function Configuration Properties] dialog box,

(opened by selecting [Option -> Emulator -> RTOS Support Function]) is selected, the following step operation

functions become applicable to the selected tasks.

• Step in

: Steps into the selected tasks.

• Step over

: Steps over the selected tasks.

• Step out

: Steps out of the selected tasks.