User`s manual

[InstructionAddress]: Set an instruction address condition.

[Don't care]: Detects no address when this box is checked.

[Value]: Detects the specified instruction address. Enter an address value.

[Point]: Enter a single value as an instruction address.

[Range]: Specify an instruction address range.

[From]: Enter a single address value or the start of the instruction address range.

[To]: Enter the end address of the instruction address range.

[Data]: Set a data condition.

[Don't care]: Detects no data when this box is checked.

[Setting]: Detects the specified data.

[Point]: Enter a single data value.

[Range]: Specify a data range.

[From]: Enter a single data value or the minimum value of the data range.

[To]: Enter the maximum value of the data range.

[Address]: Set an address condition.

[Don't care]: Detects no address when this box is checked.

[Setting]: Detects the specified address.

[Point]: Enter a single address value.

[Range]: Specify an address range.

[From]: Enter a single address value or the start of the address range.

[To]: Enter a single address or the end of the address range.

[R/W]: Select the type of access cycles.

[Don't care]: Detects no read/write condition when this box is checked.

[Setting]: Detects the specified read/write condition.

[RD]: Detects read cycles.

[WR]: Detects write cycles.