User`s manual

57
[R/W]: Select the type of access cycles.
[Don't care]: Detects no read/write condition when this box is checked.
[Setting]: Detects the specified read/write condition.
[RD]: Read cycle
[WR]: Write cycle
[Area]: Select the area being accessed.
[Don't care]: Detects no area condition when this box is checked.
[Setting]: Detects the specified area condition.
[INROM]: ROM
[INRAM]: RAM
[I/O]: I/O
[EXT-32]: 32-bit EXT (external memory)
[EXT-16]: 16-bit EXT (external memory)
[EXT-8]: 8-bit EXT (external memory)
[EMU-32]: 32-bit EMU (emulation memory)
[EMU-16]: 16-bit EMU (emulation memory)
[EMU-8]: 8-bit EMU (emulation memory)
[Status] Select the status of a bus.
[Don't care]: Detects no bus condition when this box is checked.
[Setting]: Detects the specified bus condition.
[PROG]: Prefetch cycle
[DATA]: CPU data access cycle
[DMAC]: DMAC cycle
[DTC]: DTC operation
[STACK]: Stack cycle
[Probes]: Select the status of probe signals.
[Don't care]: Detects no probe signal condition when this box is checked.
[Setting]: Detects the specified probe signal condition.
Don't care: Detects no selected probe condition.
High: The status of the probe signal is high.
Low: The status of the probe signal is low.
[IRQ]: Select the status of IRQ signals.
[Don't care]: Detects no IRQ signal condition when this box is checked.
[Setting]: Detects the specified IRQ signal condition.
Don't care: Detects no selected IRQ condition.
High: The status of the IRQ signal is high.
Low: The status of the IRQ signal is low.
[Timestamp]: Specify the time stamp value for bus cycles.
[Don't care]: Detects no time stamp value when this box is checked.
[Setting]: Detects the specified time stamp value. Enter a time stamp value.
(Every field must be filled in.)