User`s manual

3.8.4 Searching for a Trace Record

Use the [Trace Find] dialog box to search for a trace record. To open this dialog box, choose [Find...] from the

popup menu.

Figure 3.30 [Trace Find] Dialog Box

The [Trace Find] dialog box has the following options:

[General]: Sets the range for searching.

[Not designation]: Searches for information that does not match the conditions set in other

pages when this box is checked.

[Upward search]: Searches upwards when this box is checked.

[Start PTR]: Enters a PTR value to start a search.

[End PTR]: Enters a PTR value to end a search.

[InstructionAddress]: Set an instruction address condition.

[Don't care]: Detects no address when this box is checked.

[Value]: Detects the specified instruction address. Enter an address value.

[Data]: Set a data condition.

[Don't care]: Detects no data when this box is checked.

[Value]: Detects the specified data. Enter a data value.

[Address]: Set an address condition.

[Don't care]: Detects no address when this box is checked.

[Value]: Detects the specified address. Enter an address value.