Technical information

Section 3 Connectors, Switches, and LEDs
Rev. 1.00 Oct. 02, 2009 Page 14 of 22
REJ10J2064-0100
Table 3.3 Low (0)/High (1) Switches (S3)
Signal 0 1
FWE (S3-1) Low High
MD0 (S3-2) Low High
MD1 (S3-3) Low High
IO0 (S3-4) Low High
IO1 (S3-5) Low High
IO2 (S3-6) Low High
- (S3-7) - -
SQMD (S3-8) Low output from RES
(control sequence 2)
High output from RES
(control sequence 1)
3.2.7 Vcc and PVcc Switches (S5 and S6)
Select Vcc or PVcc level for the control signals according to the flash microcomputer you are
using (to program the flash microcomputer). The Vcc or PVcc level can be selected by the switch
settings of S5 and S6 (see table 3.4). The switches are inside the case. Open the upper panel by
removing the screw in each corner between the upper and lower panels. After switch setting,
reclose the case and refasten the screws.
Table 3.4 Vcc and PVcc Switches (S5 and S6)
Signal P V
FWE (S5-1) PVcc Vcc
MD0 (S5-2) PVcc Vcc
MD1 (S5-3) PVcc Vcc
IO0 (S5-4) PVcc Vcc
IO1 (S6-1) PVcc Vcc
IO2 (S6-2) PVcc Vcc