Datasheet

Section 16 Serial Communication Interface 3 (SCI3)
Rev.5.00 Nov. 02, 2005 Page 289 of 500
REJ09B0027-0500
Yes
<End>
No
Start reception
[1]
[4]
No
Yes
Read RDRF flag in SSR [2]
[3]
Clear RE bit in SCR3 to 0
Error processing
(Continued below)
Read receive data in RDR
Yes
No
OER = 1
RDRF = 1
All data received?
Read OER flag in SSR
<End>
Error processing
Overrun error processing
Clear OER flag in SSR to 0
[4]
[1] Read the OER flag in SSR to determine if
there is an error. If an overrun error has
occurred, execute overrun error processing.
[2] Read SSR and check that the RDRF flag is
set to 1, then read the receive data in RDR.
When data is read from RDR, the RDRF
flag is automatically cleared to 0.
[3] To continue serial reception, before the
MSB (bit 7) of the current frame is received,
reading the RDRF flag and reading RDR
should be finished. When data is read from
RDR, the RDRF flag is automatically
cleared to 0.
[4] If an overrun error occurs, read the OER
flag in SSR, and after performing the
appropriate error processing, clear the OER
flag to 0. Reception cannot be resumed if
the OER flag is set to 1.
Figure 16.13 Sample Serial Reception Flowchart (Clocked Synchronous Mode)