Datasheet

Section 13 Serial Communication Interface 3 (SCI3)
Rev.4.00 Nov. 02, 2005 Page 172 of 304
REJ09B0143-0400
13.3.8 Bit Rate Register (BRR)
BRR is an 8-bit register that adjusts the bit rate. The initial value of BRR is H'FF. Table 13.2
shows the relationship between the N setting in BRR and the n setting in bits CKS1 and CKS0 of
SMR in asynchronous mode. Table 13.3 shows the maximum bit rate for each frequency in
asynchronous mode. The values shown in both tables 13.2 and 13.3 are values in active (high-
speed) mode. Table 13.4 shows the relationship between the N setting in BRR and the n setting in
bits CKS1 and CKS0 in SMR in clocked synchronous mode. The values shown in table 13.4 are
values in active (high-speed) mode. The N setting in BRR and error for other operating
frequencies and bit rates can be obtained by the following formulas:
[Asynchronous Mode]
N =
φ
64 × 2
2n–1
× B
× 10
6
– 1
Error (%) = – 1 × 100






φ × 10
6
(N + 1) × B × 64 × 2
2n–1
[Clocked Synchronous Mode]
N =
φ
8 × 2
2n–1
× B
× 10
6
– 1
Note: B: Bit rate (bit/s)
N: BRR setting for baud rate generator (0 ≤ N ≤ 255)
φ: Operating frequency (MHz)
n: CKS1 and CKS0 setting for SMR (0 ≤ N ≤ 3)