Datasheet

Section 13 Serial Communication Interface 3 (SCI3)
SCI0010A_000020020300 Rev.4.00 Nov. 02, 2005 Page 163 of 304
REJ09B0143-0400
Section 13 Serial Communication Interface 3 (SCI3)
Serial Communication Interface 3 (SCI3) can handle both asynchronous and clocked synchronous
serial communication. In the asynchronous method, serial data communication can be carried out
using standard asynchronous communication chips such as a Universal Asynchronous
Receiver/Transmitter (UART) or an Asynchronous Communication Interface Adapter (ACIA). A
function is also provided for serial communication between processors (multiprocessor
communication function).
Figure 13.1 shows a block diagram of the SCI3.
13.1 Features
• Choice of asynchronous or clocked synchronous serial communication mode
• Full-duplex communication capability
The transmitter and receiver are mutually independent, enabling transmission and reception to
be executed simultaneously.
Double-buffering is used in both the transmitter and the receiver, enabling continuous
transmission and continuous reception of serial data.
• On-chip baud rate generator allows any bit rate to be selected
• External clock or on-chip baud rate generator can be selected as a transfer clock source.
• Six interrupt sources
Transmit-end, transmit-data-empty, receive-data-full, overrun error, framing error, and parity
error.
Asynchronous mode
• Data length: 7 or 8 bits
• Stop bit length: 1 or 2 bits
• Parity: Even, odd, or none
• Receive error detection: Parity, overrun, and framing errors
• Break detection: Break can be detected by reading the RxD pin level directly in the case of a
framing error
Clocked synchronous mode
• Data length: 8 bits
• Receive error detection: Overrun errors detected