User`s manual

Section 1 Specifications of the E8 Emulator

Table 1.1 shows the specifications of the R8C/10, R8C/11, R8C/12 and R8C/13 Groups E8 Emulator.

Table 1.1 Specifications of the R8C/10, R8C/11, R8C/12 and R8C/13 Groups E8 Emulator

Target MCU M16C/ Family R8C/Tiny Series

R8C/10, R8C/11, R8C/12 and R8C/13 Groups

Usable MCU mode Single-chip mode

Break function - Address-match break, 2 points

- PC break (up to 255 points)

- Forcible break

Trace function Not available

Flash memory programming function Available

User interface Clock synchronous serial interface (communicating via P00/P37/CNVss pin)

* UART1 function cannot be used in a user program

Program for the E8 Emulator ROM size: 2 KB

* Varies depending on the device. For detail, see ”Section 5 Differences

between the MCUs and the Emulator”.

Emulator power supply Unnecessary (USB bus powered, power supplied from the PC)

Interface with host machine USB (USB 1.1, full speed)

* Also connectable to host computers that support USB 2.0

Power supply function Can supply 3.3 V or 5.0 V to the target board (300 mA, max)

R8C/10, R8C/12

3.0--5.5 V (f(XIN)=16MHz)

2.7--5.5 V (f(XIN)=10MHz)

Power voltage

R8C/11, R8C/13

3.0--5.5 V (f(XIN)=20MHz)

2.7--5.5 V (f(XIN)=10MHz)