User`s manual

A further dialog will be displayed to confirm if it acceptable to assume only one E8 device will be connected to the host computer while

using this project. This is the preferred operating mode. While it is possible to use more than one E8 device this is not recommended.

• Press ‘Yes’ to assume only one E8 device is

connected while in this project.

Note: If you have not followed the Quick Start Guide, additional driver messages may be displayed here. Please refer to the Quick Start

Guide for driver installation.

The following dialog allows the selection of the baud rate and power options for connection to the target board and monitor code. The

default settings are shown below. If the target board is modified with a different crystal frequency then this setting will need to be changed.

(Note in this case the kernel will also need to be re-compiled).

• Confirm the settings shown and press <OK>.

HMon will attempt to connect to the RSK. If it succeeds then the Output window in HEW will show the ‘Connected’ message. In this case

please proceed to Chapter 6.

If the connection fails you will be returned to the previous dialog. This is likely to be caused by a connection error with the RSK and the E8.

It can also be caused if the RSK has not got a working copy of the HMon target code programmed. Check the settings and if all settings are

OK but the connection still fails then a Boot Mode download will be required. Press <Abort>.

• Select ‘Download HMon using Boot Mode’.

• Press <OK>.

On completion of the download HMon will automatically re-connect to the monitor and revert back to User programming mode.