User`s manual

• Confirm the default selections of ‘Automatic’
and ‘Advanced’.
• Press <Next>.
• The following warning dialog will be
displayed.
• Press <OK>.
To communicate with the RSK FDT and HMon need to be able to change the operating mode of the microcontroller. To do this there are
settings to control the state of the Mode pins via the E8Direct interface. These settings are confirmed in the following screens.
Unless you are very sure that the mode pin settings need to change. Do not modify the default settings.
Damage to the microcontroller can be sustained with
incorrect settings.
• Confirm the mode pin settings.
• Press <Next>.
• The following warning dialog will be
displayed.
• Press <OK>.
11