User`s manual

Chapter 6.User Circuitry
6.1.Switches
There are four switches located on the CPU board. The function of each switch and its connection are shown in Table 6-1.
Switch Function Microcontroller
RES When pressed; the CPU board microcontroller is reset. RESn
SW1/BOOT* Connects to an IRQ input for user controls.
The switch is also used in conjunction with the RES switch to place
the device in BOOT mode when not using the E8 debugger.
IRQ8-A, Pin 58
(Port 2, pin 0)
SW2* Connects to an IRQ line for user controls. IRQ9-A , Pin59
(Port 2, pin 1)
SW3* Connects to the ADC trigger input. Option link allows connection to
IRQ line. The option is a pair of 0R links.
ADTRG, Pin 57
(Port 1, pin 7)
OR
IRQ10-A, Pin 60
(Port 2, pin 2)
Table 6-1: Switch Functions
*Refer to schematic for detailed connectivity information.
6.2.LEDs
There are six LEDs on the CPU board. The green ‘POWER’ LED lights when the board is powered. The orange BOOT LED indicates the
device is in BOOT mode when lit. The four user LEDs are connected to an IO port and will light when their corresponding port pin is set low.
Table 6-2, below, shows the LED pin references and their corresponding microcontroller port pin connections.
LED Reference (As
shown on silkscreen)
Microcontroller Port Pin
function
Microcontroller Pin
Number
Polarity
LED0 Port I 0 113 Active Low
LED1 Port I 1 115 Active Low
LED2 Port I 2 118 Active Low
LED3 Port I 3 12 Active Low
Table 6-2:LED Port
6.3.Potentiometer
A single turn potentiometer is connected to AN0 of the microcontroller. This may be used to vary the input analog voltage value to this pin
between AVCC and Ground.
10