Technical information

15
3.3 Use of an Internal RAM Area as External Memory
An internal RAM area can be used as an external address when the RAME bit of the SYSCR is
cleared to 0. An emulator (optional memory) cannot be specified for the internal RAM area. Only
user memory can be accessed as an external address. Option memory cannot be accessed as an
external address. In this case, Memory Mapping must be set to Internal RAM.
3.4 Support of Flash Memory
The E6000 does not emulate the flash memory control operation in the MCU.
3.5 Hardware Standby
When the User Standby enable check box is selected in the Configuration window, the STBY
signal of the user system is directly input to the E6000.
When the STBY signal is input, the E6000 hardware is initialized and the E6000 stops emulation.
Therefore, the User Standby enable check box should be cleared (not selected) for general
emulation.