Technical information

ii
Contents
Section 1 Overview ...........................................................................................1
1.1 Environment Conditions....................................................................................................1
1.2 Supported MCUs and User System Interface Cables........................................................1
1.3 Operating Voltage and Frequency Specifications .............................................................3
Section 2 User System Interface........................................................................4
2.1 Signal Protection...............................................................................................................4
2.2 User System Interface Circuits..........................................................................................4
Section 3 Notes on Use......................................................................................14
3.1 I/O Register Differences between Actual MCU and E6000..............................................14
3.2 Access to the Reserved Area.............................................................................................14
3.3 Use of an Internal RAM Area as External Memory..........................................................15
3.4 Support of Flash Memory .................................................................................................15
3.5 Hardware Standby.............................................................................................................15
3.6 Selecting the Emulation Device ........................................................................................16
3.7 Support of the H8S/2639...................................................................................................17
3.8 Support of the H8S/2282...................................................................................................17
Section 4 HDI Parameters .................................................................................18
4.1 Address Areas ...................................................................................................................18
4.2 Access Status.....................................................................................................................19
4.3 I/O Modules ......................................................................................................................20
Section 5 Diagnostic Test Procedure.................................................................21
5.1 System Set-Up for Test Program Execution......................................................................21
5.2 Diagnostic Test Procedure Using the Test Program..........................................................22