Technical information

ii
Contents
Section 1 Overview............................................................................................1
1.1 Environment Conditions....................................................................................................1
1.2 Supported MCUs and User System Interface Cables........................................................1
1.3 Operating Voltage and Frequency Specifications .............................................................2
Section 2 User System Interface........................................................................3
2.1 Signal Protection ...............................................................................................................3
2.2 User System Interface Circuits..........................................................................................3
Section 3 Notes on Use......................................................................................6
3.1 I/O Register Differences between Actual MCU and E6000..............................................6
3.2 Access to the Reserved Area .............................................................................................6
3.3 Support of Flash Memory..................................................................................................6
3.4 Hardware Standby.............................................................................................................6
3.5 HCAN................................................................................................................................6
3.6 Procedure for Applying the Power....................................................................................7
Section 4 HDI Parameters..................................................................................8
4.1 Address Areas....................................................................................................................8
4.2 Access Status.....................................................................................................................9
4.3 I/O Modules.......................................................................................................................10
Section 5 Diagnostic Test Procedure .................................................................11
5.1 System Set-Up for Test Program Execution......................................................................11
5.2 Diagnostic Test Procedure Using the Test Program..........................................................12