Technical information

14
5.2
5.25.2
5.2 Diagnostic Test Procedure Using Tes
Diagnostic Test Procedure Using TesDiagnostic Test Procedure Using Tes
Diagnostic Test Procedure Using Test Program
t Programt Program
t Program
Insert the CD-R (HS2339EPI61SR supplied with the E6000) into the CD-ROM drive of the host
computer by pressing the Shift key, move the current directory to <Drive>:\Diag with a command
prompt, and enter one of the following commands according to the PC interface board used to
initiate the test program:
1. ISA bus interface board (HS6000EII01H)
>TM2339 ISA (RET)
2. PCI bus interface board (HS6000EIC01H, HS6000EIC02H)
>TM2339 PCI (RET)
3. PCMCIA interface card (HS6000EIP01H)
>TM2339 PCCD (RET)
The HDI must be installed before the test program is executed.
Be sure to initiate the test program from <Drive>:\Diag. Do not initiate it from a directory other
than <Drive>:\Diag, such as > <Drive>:\Diag\TM2339 ISA (RET). If the test program is
initiated when the current directory is not <Drive>:\Diag, the test program will not operate
correctly.
When S is added to the command line such as >TM2339 ISA S (RET), steps 1 to 18 will be
repeatedly executed. To stop the execution, enter Q.
Notes: 1. When the CD-R is inserted into the CD-ROM drive without pressing the Shift key, the
HDI installation wizard is automatically started.
In such a case, exit the HDI installation wizard.
2. <Drive> is a drive name for the CD-ROM drive.
3. Do not remove the CD-R from the CD-ROM drive during test program execution.