Technical information

10
3. If the reserved area other than that described in item 1 above is used, the operation in the actual
MCU cannot be guaranteed. If the user program extends to the reserved area during
debugging, select the MCU having the largest ROM capacity (for example, debug the
H8S/2332 program in the H8S/2337 mode).
4. Internal RAM (specified in each MCUs memory map) can be used as an external address area
when the RAME bit of the SYSCR is cleared to 0. Target (user memory) can be specified for
this area with the Configuration settings.
3.3
3.33.3
3.3 Support of Flash Memory
Support of Flash MemorySupport of Flash Memory
Support of Flash Memory
The E6000 does not emulate the flash memory in the MCU.
3.4
3.43.4
3.4 Hardware Standby
Hardware StandbyHardware Standby
Hardware Standby
When the User Standby enable check box is selected in the Configuration window, the STBY
signal on the user system is directly input to the E6000.
When the STBY signal is input, the E6000 hardware is initialized and the E6000 stops emulation.
Therefore, we recommend to clear the User Standby enable check box (not selected) for general
emulation.