Technical information

iii
Contents
Section 1 Overview ........................................................................................ 1
1.1 Environment Conditions....................................................................................................1
1.2 Supported MCUs and User System Interface Cables ........................................................2
1.3 Operating Voltage and Frequency Specifications..............................................................4
Section 2 User System Interface..................................................................... 6
2.1 Signal Protection ...............................................................................................................6
2.2 User System Interface Circuits ..........................................................................................6
Section 3 Notes on Use .................................................................................. 9
3.1 I/O Register Differences between Actual MCU and E6000 ..............................................9
3.2 Access to the Reserved Area .............................................................................................9
3.3 Support of Flash Memory..................................................................................................10
3.4 Hardware Standby .............................................................................................................10
Section 4 HDI Parameters .............................................................................. 11
4.1 Address Areas....................................................................................................................11
4.2 Access Status.....................................................................................................................12
4.3 I/O Module Selection ........................................................................................................12
Section 5 Diagnostic Test Procedure.............................................................. 13
5.1 System Set-Up for Test Program Execution ......................................................................13
5.2 Diagnostic Test Procedure Using Test Program................................................................14