User`s manual

211
The following messages are displayed during test. This test consists of steps 1 to 18.
Message Description
E6000 H8S/2214_62 Emulator Tests Vx.x
Copyright (c) 2003 Renesas Technology Corp.
Test program start
message. Vx.x shows the
version number.
Option memory board fitted? ( 1. None 2. 1MB 3. 4MB ) : 1 Enter 1 because the SIMM
memory module is not
installed in this
example.
Loading driver .......................OK (Use PCI)
Initializing driver ..................OK
Searching for interface card .........OK
Checking emulator is connected .......OK
Shows that the PC
interface board is
correctly installed in
the host computer and
displays the address
assigned to the board.
Emulator Board Information:
Main Board ID: H'5 Shows the ID number of
the lower board of the
E6000 (always 5).
Emulation Board ID: H'0d Shows the ID number of
the upper board of the
E6000 (always 0d).
SUB board ID: H'x Shows the revision number
of the upper board of the
E6000 as x.
Option memory board: None Shows whether the SIMM
memory board is
installed.
01) Testing Register :
A) IDR0 Register ..................OK
B) PAGE Register ..................OK
C) TRACE G/A Register..............OK
D) PERFM G/A Register..............OK
E) CES G/A Register................OK
F) IDR1 Register...................OK
G) IDR2 Register...................OK
Shows the check results
for the registers in the
E6000 (normal
completion).
02) Testing DPRAM :
A) Decode Test ....................OK
B) Marching Test ..................OK
Shows the results of
decoding test and
marching test for the
dual-port RAM in the
E6000 (normal
completion).
03) Testing Firmware RAM :
A) Decode Test page [H'700 - H'71f] ........OK
B) Marching Test page [H'700 - H'71f] ........OK
Shows the results of
decoding test and
marching test for the
firmware RAM in the E6000
(normal completion).