User`s manual

210
D.2 Diagnostic Test Procedure Using Test Program
Insert the CD-R (HS2214EPI62SR supplied with the emulator) into the CD-ROM drive of the host computer,
move the current directory to <Drive>:\Diag with a command prompt, and enter either of the following
commands according to the PC interface board in use to initiate the test program:
1. PCI bus interface board (HS6000EIC01H or HS6000EIC02H)
> TM2214_62 –PCI (RET)
2. PCMCIA interface card (HS6000EIP01H)
> TM2214_62 –PCCD (RET)
3. USB adapter (HS6000EIU01H or HS6000EIU02H)
> TM2214_62 –USB (RET)
4. LAN adapter (HS6000ELN01H)
> TM2214_62 –ELN (RET)
The High-performance Embedded Workshop must be installed before the test program is executed.
Be sure to initiate the test program from <Drive>:\Diag. Do not initiate it from a directory other than
<Drive>:\Diag, such as > <Drive>:\Diag\TM2214_62 –PCI (RET). If the test program is initiated when the
current directory is not <Drive>:\Diag, the test program will not operate correctly.
When –S is added to the command line such as >TM2214_62 –PCI –S (RET), steps 1 to 18 will be repeatedly
executed. To stop the execution, enter Q.
Notes: 1. <Drive> is a drive name for the CD-ROM drive.
2. Do not remove the CD-R from the CD-ROM drive during test program execution.