User`s manual
Table Of Contents
- This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
- 2238.pdf
- Preface
- Section 1Configuration
- Section 2Connection Procedures
- Section 3Installing the MCU to the User System
- Section 4Verifying Operation
- Section 5Notice
2.2 Connecting User System Interface Cable to User System
WARNING
Always switch OFF the user system and the emulator
product before the USER SYSTEM INTERFACE CABLE is
connected to or removed from any part. Before connecting,
make sure that pin 1 on both sides are correctly aligned.
Failure to do so will damage the user system and the
emulator product or will result in PERSONAL INJURY. The
USER PROGRAM will be LOST.
To connect the cable head to the user system, follow the instructions below.
4