User`s manual

18
7. This emulator does not support mode 7 (single-chip mode).
8. In the H8S/2218 series, the USB control register and the RTC control register are allocated to
external bus areas of area 6 (H’C00000 to H’DFFFFF) and area 7 (H’E00000 to H’FFFFFF),
respectively.
To access these registers, a bus controller must be set. For details, refer to section 3, MCU
Operating Mode, section 6, Bus Controller, and section 14, Universal Serial Bus (USB), in the
H8S/2218 Series Hardware Manual.
When using the emulator, the following register settings are required:
 Modes 6 and 7 in the H8S/2218 series (internal ROM valid mode)
Pin function control register (PFCR: H’FDEB): H’02
Bit 2 of the port 7 data direction register (P7DDR: H’FE36): 1
Port C data direction register (PCDDR: H’FE3B): H’FF
 Modes 4 and 5 in the H8S/2218 series (internal ROM invalid mode)
Pin function control register (PFCR: H’FDEB): H’02
Bit 2 of the port 7 data direction register (P7DDR: H’FE36): 1