Technical information

1 / 5

HS2214EPI61HE-P(E)

Precautions on Using the H8S/2214 Series E6000 Emulator

This section shows notes on using the H8S/2214 Series E6000 Emulator.

1 Precautions on Using the Emulator

1.1 Event

Combination of Address-Range and Data Compare-Byte

When an address range is set as the address condition and byte data as the data condition, a break will occur

only at even addresses in the address range. When an address range is set as the address condition, do not

set an odd address as the Address Lo condition. If set, a break will not occur even when the conditions are

satisfied.

1.2 Devices that cannot be Emulated Independently by E6000

When the following devices are emulated, an expansion board and a user cable are required besides the

E6000 H8S/2214 station (HS2214EPI61H). Therefore, do not select the corresponding devices when the

following expansion boards and user cables are disconnected.

Emulation Device Expansion Board and User Cable Type Number

H8S/2215 User cable for H8S/2215 HS2215ECN61H or

HS2215ECB62H

H8S/2277R, H8S/2277 H8S/2276R series expansion I/O board

for E6000 emulator or H8S/2276 series

expansion I/O board for E6000 emulator

HS2276REIO61H or

HS2276EIO61H

1.3 USB Module of the H8S/2215

Displaying the [I/O Registers] Window

In the USB registers, USB Endpoint Information Registers 00_0 to 22_4 (UEPIR00_0 to UEPIR22_4) are

defined as other modules (USB_Endpoint_Information_Registers).

Access Area

The USB module is allocated to the external bus area of area 6 (H'C00000 to H'DFFFFF).

Therefore, the access area that has been traced for this area is displayed in the external area (EXT-8).

There is no display of 'Internal IO' for areas H'C00000 to H'DFFFFF by the [Target Device Configuration]

item in the [Memory] sheet of the [System Status] window.

Note: Microsoft

, Windows

95, Windows

98, Windows NT

, and Windows

2000 are registered

trademarks of Microsoft Corporation in the United States and/or other countries.